1UP USA RACK STASH - User Manual

To Next Page

Horizontal Mounting

In the Box:

• RS Add-On Holder

• Installation Hardware

• Add-On Mounting Bolts

Tools Required:

• Drill

• 1/4” Drill Bit

• 1/2” Socket and Ratchet

• Tape Measure

• Level

• 3/8” Allen Wrench

Installation

• Begin by finding wall location to install. Unit requires two studs for horizontal

mounting and one stud for vertical mounting. 20” minimum clearance required

beyond both ends of unit.

• Use level and tape to mark and drill 1/4” pilot holes in wall for mounting. Horizontal

mounting will require four holes. Vertical mounting will require two holes.

• Use supplied lags and washers to install unit. 2” lags used for horizontal mounting.

4 1/2” lags used for vertical mounting. Spacers used for vertical mounting. Lags

should be tightened firmly.

Vertical Mounting

Spacers to install on backside

of RS Add-On Holder.

RS Add-On Holder

Need help?

Do you have a question about the 1UP USA RACK STASH and is the answer not in the manual?

Summary

Locate wall studs, ensure adequate clearance, and identify mounting hole requirements for vertical or horizontal installation.

Drill pilot holes using a 1/4" bit, then secure the unit with supplied lags and washers, tightening firmly.

Use caution during installation and periodically inspect the RS Add-On Holder for proper working condition.

Reach out for questions, review support contact, and note the warranty disclaimer regarding liability.

General