10
EN
Button functions
Button Current state Corresponding action
Power Standby
Short press: power on/off (Note: the display will
light up after output is turned on)
DC Power on Short press: turn on/off the DC output
USB Power on Short press: turn on/off the USB output
LED Power on
Short press: turn on the light (brightness 1-2)>
SOS > Strobe > Turn off the light
SET Power on Short press: enter/exit settings menu
UP Power on Short press: Previous selection
DOWN Power on Short press: Next selection
ENT Power on Short press in settings menu: confirm/enter option
Note. When the device is turned on press AC button to turn on the screen. When the
screen backlight is off, press SET, UP, DOWN or ENT button to turn on the backlight.
Warning: Changing the settings can damage the components and cause the charging
station and devices connected to it to fail. The manufacturer is not responsible for direct or
indirect damages caused by changing these parameters.
To enter the setting menu and exit the setting menu, press the “SET” button. After entering
the setting menu, the parameter number [00] will flash. Press the “UP” and “DOWN”
buttons to select the code of the parameter item to be set. Then press the “ENT” button to
enter the parameter editing state. The value of the parameter will be flashing. Adjust the
value of the parameter through the “UP” and “DOWN” buttons, and finally press the “ENT”
button to complete the parameter editing and return to the parameter selection state.
To Next Page
Loading...