2gig Technologies 2GIG-KEY2-345 User Manual

1
2GIG-KEY2-345
4-BUTTON KEYFOB REMOTE
INSTALLATION INSTRUCTIONS
The2GIG4‐ButtonKeyfobRemote(2GIG‐KEY2‐345)communicates
withthe2GIGControlPanelonthe345MHzfrequency.Itgivesusers
theabilitytoturnthesecuritysystemONandOFFbeforeenteringthe
homeorafterexiting.Ifthereisanemergency,youcanturnonthe
siren
andautomaticallycallthecentralmonitoringstation.Keyfobs
canbeprogrammedtooperatetheprogrammableoutputinthe
ControlPanel.Usewiththe2GIGUniversalGarageDoorReceiver
(2GIG‐GDR1‐345)toopenagaragedoor.Thekeyfobisalithiumcoin
battery‐powered,wirelesskeyfobdesignedtofiton
akeychain,ina
pocket,orinapurse.Itprovidesaconvenientoptionforthefollowing
systemoperations:
•Armthesystem(doors,windows,andmotionsensors)
•Armthesystemwithnoentrydelay(ifprogrammed)
•Disarmthesystem
•Triggerpanicalarms
•Turnsystem‐controlledlightsonoroff(viatheopen
collector
output)
•Otheropencollect oroutputfunctions(ifapplicable)
•Usewiththe2GIG‐GDR1‐345toopenagaragedoor.Seethe
2GIG‐GDR1‐345InstallationInstructions.
Contents
Verifythatthepackageincludesthefollowing:
•1—4‐ButtonKeyfobRemote
•1—KeyRing
• 1—LithiumCoinBattery(included)
Figure 1 4‐ButtonKeyfobRemote
Programming
Usethefollowingguidelinestoaddkeyfobstothesystem.Fordetailed
instructions,referto“Wireless(RF)KeyfobProgramming”inthe
ControlPanel’ sInstallation&ProgrammingGuide:
•Program(learn)thekeyfobsintothecontrolpanelasnon‐
supervisedsensors.
•Eachlearnedkeyfobusesoneoftheavailablesensornumbers.
For
moredetails,refertothe2GIG‐GDR1‐345InstallationInstructions.
Usethefollowingguidelinestoaddkeyfobstothe2GIG‐GDR1‐345:
•Pressandreleasethelearnbutton.
•Thelearnindicatorwilllightifthere’sroominmemory
•Activatethe*(Auxiliary)buttononthetransmitterwhilethe
indicatorislit
(within15seconds)
• Receive rindicatorflashes
•Repeatstepsforadditionaltransmitters(upto10)
Testing
RefertotheControlPanel’sInstallation&ProgrammingGuidetolearn
howtoinitiatepaneltestmode.
Testthekeyfobbypressingeachoneofthekeyfobbuttons:
• Disarmbutton.Holdfortwo (2)secondstodisarmtheControl
Panel.Door s,windows,andmotionsensorsaredisarmed.
• Awaybutton.
Holdfortwo(2)secondstoarmtheControl
PanelinAwaymode.Doors,windows,andmotionsensorsare
armed.
• Staybutton.Holdfortwo(2)secondstoarmtheControlPanel
inStaymode.Doorsandwindowsarearmed.
• Auxiliarybutton.Ifprogrammed,cantriggerapre‐selected
output.SeetheControlPanel’ sInstallation&Programming
Guidefordetails.
• Away&Disarmbuttons.Ifprogrammed,pressingBOTHthe
AwayandDisarmbuttonsatthesametimeforfive(5)
seconds,willsendoneoffourtypesofemergencysignals:(1)
silentpanic;(2)audiblealarm;(3)silentpanic;
or(4)fire.
NOTE: Itisrecommendedthatasystemtestbeperformedper
theControlPanel’sInstallation&ProgrammingGuideatleast
onceayear.
Inserting and Replacing the Battery
Thekeyfobarrivesreadytouse(batteriesalreadyinstalled).
Toreplacethebattery:
1 Removethescrewfromthebackofthekeyfob.
2 Separatethekeyfob’sfaceplatefromitsbackpl ate.
3 Slidetheexistingbatteryoutfromunderthemetalbatteryclipon
theprintedcircuitboard.
IMPORTANT: Alwaysdisposeand/orrecycleusedbatteriesin
accordancewiththehazardouswasterecoveryandre cycling
regulationsforyourlocation.Yourcity,state,orcountrymay
alsorequireyoutocomplywithadditionalhandling,recycling,
anddisposalrequirements.
4 Insertthereplacementbatteryintothemetalbatterycliponthe
printedcircuitboard.Theplus(+)signonthebatteryshouldbe
facingupandtheminus(‐)sidefacingdownasillustratedbelow.
Figure 2 4-Button Keyfob Remote—Battery Compartment
5 Replacetheprintedcircuitboardintothefaceplateofthekeyfob.
A Awaybutton
B Disarmbutton
C Staybutton
D Auxiliarybutton
E Keyring

2gig Technologies 2GIG-KEY2-345 Specifications

General

Brand	2gig Technologies
Model	2GIG-KEY2-345
Category	Remote Control
Language	English

Summary

Installation Instructions

Programming Keyfobs

Learn keyfobs into the control panel as non-supervised sensors using available sensor numbers.

Keyfob Testing

Test each keyfob button by pressing and holding for two seconds to verify system response.

Inserting and Replacing the Battery

Specifications

Regulatory Information

FCC Notice

Details compliance with FCC rules, including conditions for operation and interference.

Industry Canada (IC) Compliance

Outlines compliance with Industry Canada license-exempt RSS standards and operating conditions.

Limited Warranty