3 Embers GAS9675AF User Manual (English)

Other manuals for 3 Embers GAS9675AF

Questions and Answers:

E
emmablackAug 18, 2025
Why my 3 Embers GAS9675AF doesn't get hot enough?
- M
  Melanie BrownAug 18, 2025
  If your 3 Embers Grill isn't getting hot enough, the possible causes are: * The LP gas tank may be out of gas - replace or refill it. * A flow limiting device may have been activated. Try a mini reset by turning the control knobs and LP gas tank valve to “OFF”, wait one minute, and relight the grill. If that doesn't work, perform a full reset: Turn control knobs and LP gas tank valve to “OFF”, disconnect the regulator from the propane tank, inspect the LP cylinder rubber seal, wait 1 minute, reconnect the regulator, perform “Leak Testing” on all connections, and light the grill.
D
Devon SmithAug 21, 2025
What to do if 3 Embers Grill has flare-up?
- E
  Edward ReynoldsAug 21, 2025
  If your 3 Embers Grill experiences a flare-up, it could be due to: * Grease buildup: Clean all grill parts. * Excess fat in meat: Trim fat from meat before grilling. * Excessive cooking temperature: Adjust (lower) cooking temperature.
S
Samuel MooreAug 25, 2025
Why does the flame keep blowing out on my 3 Embers GAS9675AF Grill?
- K
  Kerry SerranoAug 26, 2025
  The flame on your 3 Embers Grill might be blowing out due to: * High or gusting winds: Avoid using the grill in high winds. * Low LP gas: Replace or refill the LP gas tank.
S
sullivantiffanyAug 28, 2025
What to do if there is a grease fire in my 3 Embers GAS9675AF Grill?
- M
  martin49Aug 28, 2025
  If there's a grease fire in your 3 Embers Grill: 1. Turn control knobs and LP gas tank valve to “OFF”. 2. Leave lid in open or closed position and let fire burn out. Use BC type fire extinguisher or baking soda, sand or dirt to smother fire, if necessary. 3. After grill cools, remove and clean all parts.
D
Dr. Jeffrey HoSep 1, 2025
Why is the flame pattern irregular on my 3 Embers GAS9675AF?
- M
  Mary HuertaSep 1, 2025
  An irregular flame pattern on your 3 Embers Grill, where the flame doesn't run the full length of the burner, can be caused by: * Clogged or blocked burner ports: Clean the burner ports.
R
Randall FordSep 4, 2025
Why is the flame yellow or orange on my 3 Embers GAS9675AF?
- T
  Tony HernandezSep 4, 2025
  A yellow or orange flame on your 3 Embers Grill could be due to: * New burner may have residual manufacturing oils: Burn grill for 15 minutes on “HIGH” with the lid closed. * Spider webs or insect nest in venturi: Clean venturi and burner assembly. * Food residue, grease, etc.: Clean burner assembly. * Poor alignment of valve to burner venturi: Make sure burner venturi is properly engaged with valve.
J
Justin EvansSep 7, 2025
What causes flashback (fire in burner tubes) or melting knobs on a 3 Embers GAS9675AF Grill?
- T
  Troy WeissSep 7, 2025
  Flashback (fire in burner tubes) or melting knobs on your 3 Embers Grill is caused by: * Burner and/or burner tubes are blocked: Clean burners and/or burner assembly.
N
Nicholas GibsonSep 12, 2025
Why is the inside of my 3 Embers Grill lid peeling?
- S
  Shannon RobertsSep 12, 2025
  If the inside of your 3 Embers Grill lid is peeling, it's likely because: * Baked on grease buildup has turned into carbon and is flaking off: Clean thoroughly.

3 Embers GAS9675AF Specifications

General

Type	Gas Grill
Burners	4
BTU Output	48000 BTU
Material	Stainless Steel
Fuel Type	Propane
Grate Material	Porcelain-Coated Cast Iron
BTU	48000 BTU
Ignition Type	Electronic
Number of Burners	4
Dimensions	54.3 in. W x 25.6 in. D x 47.2 in. H
Weight	110 pounds

Related product manuals

3 Embers GAS9675AF Professional Installation Manual

Other manuals for 3 Embers GAS9675AF

Questions and Answers:

3 Embers GAS9675AF Specifications

Related product manuals