It is advised that you wash your tripod after
using it in salt water, sand, dirt or mud and
this can be done by undoing each leg. Take
each individual leg lock and unscrew until
completely undone, and gently pull the tubing
(a) out, being careful not to lose the nylon shim
(b) (chicken lips), allowing you to clean the
threads of the legs. Once cleaned, dry all the
parts with a clean cloth. Do not leave them to
air dry. Then ensure that the chicken lips are in
place and then carefully insert the leg, lining up
the internal slot with the gap (c) in the chicken
lips, and tighten the leg lock in place.
Cleaning
a
c
b
To Next Page
Loading...
Need help?
General
