3Com 4500 - Page 8

8
delete static-routes all
Delete all the static routes Device -> IP Route
dhcp-server [x] ip Configure the IP address of the DHCP Server used by the
DHCP Server group. X= group number
domain
Configure an ISP domain or enter the view of an existing ISP
domain
dot1x
Specify 802.1x configuration information
dot1x authentication-method
Specify authentication method for 802.1x users
dot1x dhcp-launch
Trigger system authentication when receiving DHCP packet(s)
dot1x max-user
Specify maximal on-line user number per port
dot1x port-control
Specify port authenticated status
dot1x port-method
Specify port controlled method
dot1x quiet-period
Enable quiet period timer
dot1x retry
Specify maximal request times
dot1x supp-proxy-check
Check whether user(s) access the networks by proxy or not
dot1x timer
Specify timer parameters
dot1x timer handshake-period
Set the handshake period of 802.1x
end-station polling ip-
address
Configure the Switch to periodically test specified end-
stations by sending PING packets
execute
Run the batch file
fabric-port [x] enable
Specify the fabric port of the Switch. Specify x = Gig interface Port -> Administration
file prompt
Modify prompt modes of file operations
ftm stacking-vlan
Specify the stacking VLAN of the Switch Device -> XRN Fabric
ftp server
Start or shutdown the FTP server
ftp timeout
Configure the FTP connection timeout interval
header
Define the login banner
igmp-snooping enable
IGMP snooping enable Device -> IGMP Snooping
igmp-snooping disable
IGMP snooping disable
igmp-snooping host-aging-
time
Configure the port aging time of the multicast group
members
igmp-snooping max-response-
time
Configure the maximum response time for a query
igmp-snooping router-aging-
time
Configure the router port aging time of IGMP Snooping
info-center channel name
Rename a channel
info-center console channel
Configure the channel through which log information is
output to the console
info-center enable
Enable the system log
info-center logbuffer
Configure to output information to the memory buffer
info-center monitor channel
Configure the channel to output the log information to the
user terminal
info-center snmp channel
Specify new channel for transmitting the SNMP information
info-center source
Add or delete a record to the information channel
info-center switch-on
Turn on the information synchronization on the specified
Switch
info-center timestamp
Configure the timestamp output format in debugging/trap
information
info-center trapbuffer
Output information to the trap buffer
interface Gig Ethernet
Enter Ethernet Port View (See Ta ble 15, “Ethernet Port View,”
on page 15)
interface vlan-interface
Enable VLAN interface and enter VLAN interface view (See
Table 14, “
VLAN Inteface View,” on page 14)
Device -> VLAN Interface
Administration -> IP Setup
ip host
Configure the host name and the host IP address
Command Description Web Command