Setting Up the Computer to Use an Ethernet Connection
27
For the Windows 2000 Operating System
1 Right-click the My Network Places icon on the Windows
desktop.
2 Right-click on Local Area Connection and click Properties.
3 A list of installed network components appears. Look for
an entry named TCP/IP.
Windows 2000 TCP/IP binding
If a similar entry is present, you can now connect the cable
modem. Go to “Connecting the Cable Modem” for the
instructions. However, if a similar entry is not present,
complete the following steps.
1 Scroll to the Internet Protocol (TCP/IP) option. Click to place
a check mark in the Internet Protocol check box.
2 Click OK.
Configuring the TCP/IP Protocol on a Macintosh
You need to make sure the TCP/IP communications
protocol and an Ethernet device is installed on the
computer before you install the cable modem. Many
Macintosh computers have Ethernet devices installed at the
factory.
1 Click the Apple icon in the upper left corner of the Finder.
Scroll down to Control Panels, and click TCP/IP.
To Next Page
Loading...