3Com EtherLink - Loading the 3 Com EtherLink Server CD; Copying the Driver; Specifying the Slot Number

– 12 –
ENGLISH
Load the
3Com
EtherLink Server CD
Copy the Driver
1 Enter this command at the prompt:
NetWare 4.2:
load install
NetWare 5.x:
load nwconfig
2 In the Configuration Options screen, select
Driver options
.
3 In the Driver Options screen, select
Configure network drivers.
4 In the Additional Driver Actions screen, select
Select a driver
.
The Select a Driver screen appears, listing all previously saved drivers in
the system.
If this is the first installation of the 3Com server NIC driver, it does not
appear in this list.
5Press Insert.
A system message for selecting a disk drive appears.
6Press F3.
7 Enter a path to the volume that contains the driver. For example:
ECD210P980X:\nwserver
The Select a Driver to Install screen appears with the 3Com EtherLink
Server NIC driver name highlighted.
8 Press Enter to select the driver.
9 Select
Yes
at the prompt to confirm the name of the driver to copy.
The installation program copies the driver to the appropriate server
subdirectory. The Configuration screen appears.
Specify the Slot Number
You do not need to specify the slot number if you are installing only one
NIC.
1 In the Configuration screen, select
Slot Number
.
2 Enter the slot number of the NIC that you want to install. For example:
10001
NetWare 4.2 Insert the CD in the CD-ROM drive and enter these commands:
load cdrom
cd mount ecd210p980x
NetWare 5.x Insert the CD in the CD-ROM drive and enter this command:
load cdrom
Wait for the message that states the CD is mounted
successfully, and then proceed to copy the driver.
QuickGuideMulti.book Page 12 Thursday, October 26, 2000 11:49 AM