– 14 –
ENGLISH
4 Enter this command:
ECD210P980X:\nwserver
The following message appears:
5Press Enter.
The system copies the Dynamic
Access
technology server features
software to the SYS volume.
Verify the Installation and Configuration
To verify that the driver has been properly loaded on the NetWare server,
perform the following procedure:
1 At the system prompt, enter:
load monitor
The NetWare Monitor screen appears.
2From the
Available Options
menu, select
LAN/WAN Drivers
.
The
Available LAN Driver
menu appears. If the driver has been loaded
properly, the driver and frame types associated with the driver appear on
this menu.
3 Select a driver to view its associated statistics.
A functioning driver displays packets being sent and received.
To verify that the server is communicating over the network:
1 Set up a NetWare client on a LAN supported by the server to be tested.
2 Log in or map to the server.
If you cannot log in or map to the server, the link is not functional.
If the link is functional, the following message appears:
Link integrity test for primary slot #XXXXX passed.
Product “3Com DynamicAccess Server Features” was
found. Verify that this is the product you want
to install before proceeding.
Press <ENTER> to continue.
Press <ESC> to abort installation.
QuickGuideMulti.book Page 14 Thursday, October 26, 2000 11:49 AM
To Next Page
Loading...
