2-2 CHAPTER 2: INSTALLING THE NIC
7 Insert the 3C905B-TX NIC into an empty PCI slot,
shown in Figure 2-1.
Make sure that the NIC is firmly seated in the slot.
Figure 2-1 Inserting the NIC
8 Secure the NIC with the screw you removed earlier.
If you are installing the Remote Wake-Up connector, go to
“Connecting the Remote Wake-up Cable” at the end of
the chapter before replacing the PC cover.
9 Replace the PC cover and reconnect all previously
connected cables.
10 Turn on the power to the PC.
11 Proceed to the next section, “Connecting to the
Network.”
PCI slot
3C905B-TX NIC
Screw
To Next Page
Loading...
