Chapter 6 Page 139
6. Click the direction in which you want to write data, or click Do
Nothing to skip data transfer for an application.
Note: Changing the HotSync setting from the default affects
only the next HotSync operation. Thereafter, the HotSync
Actions revert to their default settings. To use a new
setting on an ongoing basis, select the Set As Default box.
Thereafter, whatever you selected as the default setting is
used when you click the Default button in the Custom
dialog.
7. Click OK.
8. Repeat steps 4 through 7 to change conduit settings for other
applications.
9. Click Done to activate your settings.
To Next Page
Loading...
