For More Information
2
-7
Testing the
Installation
To test the installation of your modem, use any communications software
package, such as Windows Terminal, HyperTerminal, Procomm Plus, or
RapidComm. HyperTerminal is used in this documentation as an example.
Every communications program is different; consult the documentation
that came with your communications program for more information.
1 Run HyperTerminal.
2 When the first window appears, enter the name of your connection in
the Name field and click OK.
3 Enter the phone number you want to dial and click OK. If you only want
to test your modem, you may enter any number.
4 See the table below.
When the HyperTerminal terminal window appears, type AT and hit
<ENTER>. If your modem is connected properly, "OK" will appear on the
terminal screen.
For More
Information
The 3Com OfficeConnect 56K Business Modem Command
Reference
Be sure to investigate the Command Reference for this product (located
on the Connections CD-ROM) if you are looking for additional technical
information about your modem (including s-registers, AT commands, and
specifications), step by step configuration instructions, or detailed
troubleshooting information
To view the Command Reference, install the Connections CD-ROM using
the instructions in the CD’s liner notes as a guide. Once Connections is
installed, launch the software (click Start/Programs/3Com
U.S.Robotics/Connections). From the main Connections interface, click
User Guides and then select the guide for your modem.
In order to Click this button
Dial a number Dial
Test without dialing a number Cancel
To Next Page
Loading...
