Installing Your Business Modem
2
-3
3 Keeping the front of the units aligned, position the modem on top of the
OfficeConnect device and rest the bottom of the modem on the clips'
spikes, as shown in step 3 of the following illustration. Push the clips
firmly into the modem until they click into place.
NOTE: To remove a clip, hold the units firmly with one hand and hook the
first finger of your other hand around the back of the clip. Be careful not
to pull so hard that you break the clip.
4 Repeat these steps to secure the other side.
Hardware Installation Look at the back of your computer for a port
Refer to your computer’s documentation to locate the serial port.After
you have selected the correct cable, connect the male DB-25 end of your
If you have Ports may be labeled this way:
An IBM
compatible PC
COM, RS-232 or with symbols such as:
IOIOI
A Macintosh
Modem port
Printer port
To Next Page
Loading...
