6 CHAPTER 1: 3COM ROUTER 6000/3000 DSL FAMILY RELEASE NOTES SOFTWARE V 2.01
■ The SNMP Trap enable default is incorrectly documented. All traps are enabled
when the snmp-agent command is executed
■ Firewall ASPF UDP detection does not support the following UDP based
applications: TFTP, SSH, DHCP.
■ Named access list is documented but not supported. Named access list is not
supported in this release
■ ACL numbering scheme is different from that documented. The following is
the corrected numbering scheme:
1000-1099(Interface-based ACL)
2000-2099(Basic ACL)
3000-3099(Advanced ACL)
4000-4999(Ethernet Frame Header ACL)
■ The Command Reference Manual states that reset ike sa will clear both
phase 1 and phase 2 security associations.
reset ike sa will only clear phase 1 security associations; “reset ipsec sa” will
clear phase 2 security associations
■ MPLS LDP loop detect cannot be configured after LDP is enabled on interface.
An error is reported. Enable LDP loop detect under system view before enabling
LDP on the interface.
To Previous Page
Loading...
