288 CHAPTER 11: 802.1X CONFIGURATION
Table 332 Displaying and Debugging AAA and RADIUS Protocol
AAA and RADIUS
Protocol Configuration
Example
For the hybrid configuration example of AAA/RADIUS protocol and 802.1x
protocol, refer to
“802.1x Configuration Example” on page 266.
Configuring the FTP/Telnet User Authentication at a Remote RADIUS
Server
Configuring Telnet user authentication at the remote server is similar to
configuring FTP users. The following description is based on Telnet users.
Operation Command
Display the configuration information of
the specified or all the ISP domains.
display domain [
isp_name
]
Display related information of user’s
connection
display connection [ access-type {
dot1x | mac-authentication } |
domain
domain_name
| interface
interface_type interface_number
|
ip
ip_address
| mac
mac_address
|
radius-scheme
radius_scheme_name
|
vlan
vlanid
| ucibindex
ucib_index
|
user-name
user_name
]
Display related information of the local user display local-user [ domain
isp_name
| idle-cut { disable |
enable } | service-type
{ telnet |
ftp | lan-access | ssh |
terminal }
| state { active | block } |
user-name
user_name
| vlan
vlan_id
]
Display the statistics of local RADIUS
authentication server
display local-server statistics
Display the configuration information of all
the RADIUS schemes or a specified one
display radius [
radius_scheme_name
]
Display the statistics of RADIUS packets display radius statistics
Display the stopping accounting requests
saved in buffer without response (from
System View)
display stop-accounting-buffer {
radius-scheme
radius_scheme_name
|
session-id
session_id
| time-range
start_time stop_time
| user-name
user_name
}
Delete the stopping accounting requests
saved in buffer without response (from
System View)
reset stop-accounting-buffer {
radius-scheme
radius_scheme_name
|
session-id
session_id
| time-range
start_time stop_time
| user-name
user_name
}
Clear stop-accounting packets from the
buffer.
reset stop-accounting-buffer {
radius-scheme
radius_scheme_name
|
session-id
session_id
| time-range
start_time stop_time
| user-name
user_name
}
Reset the statistics of RADIUS server. reset radius statistics
Enable RADIUS packet debugging debugging radius packet
Disable RADIUS packet debugging undo debugging radius packet
Enable debugging of localRADIUS scheme debugging local-server { all |
error | event | packet }
Disable debugging of localRADIUS scheme undo debugging local-server { all |
error | event | packet }
To Next Page