Configuring File Management 297
Perform the following configuration in System View.
Tab le 335 Execute the Specified Batch File
Storage Device
Operation
The file system can be used to format a specified memory device. You can use the
following commands to format a specified memory device.
Perform the following configuration in User View.
Tab le 336 Storage Device Operation
Setting the Prompt
Mode of the File System
The following command can be used for setting the prompt mode of the current
file system.
Perform the following configuration in System View.
Tab le 337 File System Operation
Configuring File
Management
The management module of the configuration file provides a user-friendly
operation interface. It saves the configuration of the Switch in the text format of
command line to record the whole configuration process. Thus you can view the
configuration information conveniently.
The format of the configuration file includes:
■ It is saved in the command format.
■ Only the non-default constants will be saved
■ The organization of commands is based on command views. The commands in
the same command mode are sorted in one section. The sections are separated
with a blank line or a comment line (a comment line begins with exclamation
mark “#”).
■ Generally, the sections in the file are arranged in the following order: system
configuration, ethernet port configuration, VLAN interface configuration,
routing protocol configuration and so on.
■ It ends with “return”.
The management over the configuration files includes:
■ Display the current-configuration and saved-configuration of the Switch
■ Save the current-configuration
■ Erase configuration files from Flash Memory
Operation Command
Execute the specified batch file execute
filename
Operation Command
Format the storage device format
filesystem
Operation Command
Set the file system prompt mode. file prompt { alert | quiet }
To Next Page