Logging Function 335
If you want to view the debugging information of some modules on the Switch,
you must select debugging as the information type when configuring information
source, meantime using the
debugging command to turn on the debugging
Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View.
Tab le 399 Configuring the Output Format of Time-stamp
4 Enabling terminal display function
To view the output information at the Telnet terminal or dumb terminal, you must
first enable the corresponding log, debugging and trap information functions at
the Switch.
For example, if you have set the log information as the information sent to the
Telnet terminal or dumb terminal, you need to use the
terminal logging
command to enable the terminal display function of log information on the
Switch, then you can view the information at the Telnet terminal or dumb
terminal.
Perform the following operation in User View.
Tab le 400 Enabling Terminal Display Function
Sending the Information
to the Log Buffer
To send information to the log buffer, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Tab le 401 Enabling/Disabling Info-center
Operation Command
Configure the output format of the
time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled undo info-center timestamp { log |
trap | debugging }
Operation Command
Enable terminal display function of log, debugging
and trap information
terminal monitor
Disable terminal display function of the above
information
undo terminal monitor
Enable terminal display function of debugging
information
terminal debugging
Disable terminal display function of debugging
information
undo terminal debugging
Enable terminal display function of log information terminal logging
Disable terminal display function of log information undo terminal logging
Enable terminal display function of trap information terminal trapping
Disable terminal display function of trap information undo terminal trapping
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
To Next Page