338 CHAPTER 12: FILE SYSTEM MANAGEMENT
When defining the information sent to the trap buffer,
channel-number
or
channel-name
must be set to the channel that corresponds to the Console
direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there
is no specific configuration record for a module in the channel, use the default
one.
If you want to view the debugging information of some modules on the Switch,
you must select debugging as the information type when configuring information
source, meantime using the
debugging command to turn on the debugging
Switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in System View.
Table 408 Configuring the Output Format of Time-stamp
Sending the Information
to SNMP Network
Management
To send information to SNMP NM, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 409 Enabling/Disabling Info-center
Info-center is enabled by default. After info-center is enabled, system
performances are affected when the system processes much information because
of information classification and outputting.
2 Configuring to output information to SNMP NM
Perform the following operation in System View.
Table 410 Configuring to Output Information to SNMP NM
3 Configuring the information source on the Switch.
Operation Command
Configure the output format of
the time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
Output time-stamp is disabled undo info-center timestamp { log | trap |
debugging }
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
Operation Command
Output information to SNMP NM info-center snmp channel {
channel-number
|
channel-name
}
Cancel the configuration of outputting
information to SNMP NM
undo info-center snmp channel
To Next Page