SNMP Configuration 347
Tab le 417 Enable/Disable SNMP Agent to Send Trap
Setting the Destination
Address of Trap
You can use the following commands to set or delete the destination address of
the trap.
Perform the following configuration in System View.
Tab le 418 Set the Destination Address of Trap
Setting Lifetime of Trap
Message
You can use the following command to set the lifetime of a Trap message. A trap
message that exists longer than the set lifetime will be dropped.
Perform the following configuration in System View.
Tab le 419 Set the Lifetime of Trap Message
By default, the lifetime of Trap message is 120 seconds.
Setting SNMP System
Information
The SNMP system information includes the character string sysContact (system
contact), the character string describing the system location, the version
information about the SNMP operating in the system.
You can use the following commands to set the system information.
Perform the following configuration in System View.
Tab le 420 Set SNMP System Information
Operation Command
Enable to send trap snmp-agent trap enable [ configuration | flash |
ospf [
process-id
] [
ospf-trap-list
] | standard
[ authentication | coldstart | linkdown | linkup
| warmstart ]* | system ]
Disable to send trap undo snmp-agent trap enable [ bgp [
backwardtransition ] [ established ] |
configuration | flash | ospf [
process-id
] [
ospf-trap-list
] | standard [ authentication |
coldstart | linkdown | linkup | warmstart ]* |
system ]
Operation Command
Set the destination
address of trap
snmp-agent target-host trap address udp-domain
host-addr
[ udp-port
udp-port-number
] params
securityname
community-string
[ v1 | v2c | v3 [
authentication | privacy ] ]
Delete the destination
address of trap
undo snmp-agent target-host
host-addr
securityname
community-string
Operation Command
Set lifetime of Trap message snmp-agent trap life
seconds
Restore lifetime of Trap message undo snmp-agent trap life
Operation Command
Set SNMP System Information snmp-agent sys-info { contact
sysContact
|
location
syslocation
| version { { v1 | v2c
| v3 } * | all } }
To Next Page