6.3. Slide load left X
This value defines the X coordinate of the Slide’s left-hand position. Mostly, the software calculates this value precisely. Click Slide load left X
and click Go to II to navigate the unit to the calculated position. It is correct if the front-left arm collides and opens but the front-right arm
avoids the pin. In case of improper operation, navigate the unit to the intended position. Click on the side panel to set this value.
6.4. Slide load right X
This value defines the X coordinate of the slide’s right-side insertion. Mostly, the software calculates this value precisely. Click Slide load right
X and click Go to II to navigate the unit to the calculated position. It is correct if the front-right arm collides and opens but the front-left arm
avoids the pin. In case of improper operation, navigate the unit to the intended position. Click on the side panel to set this value.
6.5. Stage controls
Here, we can test our earlier adjustments. Test all options: the unit must not stall or collide. In case of proper operation, set the unit to fully
open state.
To Next Page
Loading...
