-Masking tape
-Hobby knife with #11 blades
-Razor saw
-Thin and medium CA.
-Blue Loctite.
-Silicon based glue (Zap-A-Dap-A-Goo, etc.)
-Electric drill with an assortment of small drill bits.
-Small flat head and Phillips head screw drivers.
-Standard and needle nose pliers.
-Metric balldriver or allen key set.
-4 sub micro metal geared servos. All flight testing was performed with Hitec HS-65MG
and HS-5065MG digital servos and we strongly recommend the use of either of these high
quality servos.
-Torque 2818T/900 Brushless Outrunner motor.
-Airboss Elite 45 Amp ESC.
-3S 2100-2700 mah LiPo battery.
-APC 12x6 E prop (NOT the slow fly version!).
-52 mm Extreme Flight spinner.
-1 18"-24" extensions for the elevator servo and 2 6"-8" extensions to go between the
receiver and the aileron servo leads. We recommend the 28 or 32 AWG extensions to save
weight.
-Adhesive backed Velcro and Velcro strap for battery retention.
Let's begin!
4
To Next Page
Loading...