3M
™
Mining Cable Splice Kit 3100
Instructions
Kit Contents:
1 Scotch
®
Heavy Duty Mining Tape 31, 2" x 8.5'
1 Scotch
®
Linerless Rubber Splicing Tape 130C, 1½" x 30'
1 3M
™
Temflex
™
Vinyl Electrical Tape 1700P, 1½" x 44'
1 3M
™
Cable Cleaning Preparation Kit CC-2-Dry
1 Instruction Sheet
Note: Scotch
®
Linerless Rubber Splicing Tape 130C is applied highly-stretched with
tacky side DOWN.
Technical Information:
For use on 2, 3 or 4-Conductor Flat Type W, G or G-GC
3 or 4-Conductor Round Type W, G or G-GC
#6 AWG–1/0 AWG (14-50 mm
2
)
600 V–2 kV
Cables up tp 500 kcmil (250 mm
2
) will require the use of additional tapes.
Mine Safety and Health Administration Acceptance:
P-07-KA080005/00-MSHA
DANGER
Before attempting any cable repairs, make sure that the proper cable is
disconnected, locked out and suitably tagged.
CAUTION
Working around energized systems may cause serious injury or death. Installation
should be performed by personnel familiar with good safety practice in handling
electrical equipment. De-energize and ground all electrical systems before installing
product.
August 2009
78-8127-6830-3-C
To Next Page
Need help?
General
