3M FAP01-RS - Filter Handling; Filter Removal; Filter Replacement; Troubleshooting and Compliance

4
• While holding the device in place with
one hand, release the front cover
with the other hand by grasping and
gently pulling the cover toward you.
• Lift the lter cover and set it aside.
• Remove the used lter by placing
your ngers in the recesses at the
top of the lter and pressing the lter
frame down. The lter will disengage
from the top holding lip and can be
pulled out.
• Dispose of the used lter properly.
• For FAP02 and FAP03 reset the lter
timer by holding down the FILTER
CHANGE button for three seconds.
A red light comes on. Before it
disappears, the light will start ashing
quickly as you continue to hold the
button. The timer is reset.
Fi l t e r re m o v a l
• Remove the plastic wrapper and
paper insert on the Air Purier
replacement lter.
• Place the bottom edge of
replacement lter in the lter slot
and gently push the top of the lter
down in two places, while pushing
it forward. When the lter clears the
holding lip, release the lter.
• Replace the front cover by placing
the bottom tabs of the cover into the
cavities in the base of the Air Purier.
Push the top of the cover towards
the device until the cover locks into
place.
Caution
• Dispose of the Air Purier, and lters
in accordance with local regulations.
• On FAP01 replace the lter when
the lter change timer nishes its
rotation.
• On FAP02 and FAP03 replace the
lter when the lter change timer
begins ashing red. Change the lter
after at least 90 days continuous
use or sooner depending upon the
conditions in your home.
• Periodic inspection of the lter for
damage or blockage is strongly
recommended.
Fi l t e r re P l a C e m e n t
Warning
• Do not modify or attempt to modify
this product.
• Do not disassemble the Air Purier.
• Except for lter replacement, the Air
Purier is not intended to be serviced
and does not contain any serviceable
replacement parts or adjustments.
trouble
If replacement filter doesn’t fit:
• Check the model number to ensure
the lter matches the model number.
• Make sure that the bottom of the
lter is placed and centered on the
protrusion at the bottom of the lter
opening.
• A small downward force is needed to
place the lter in the opening.
• Make sure that no foreign objects are
blocking the lter opening.
Air Purifier will not turn on:
• Be sure the Air Purier is properly
plugged into a 240V AC wall socket.
• Be sure the Air Purier is turned on.
• Check if the fuse is blown or if a
circuit breaker has been tripped.
Decreased airflow:
• Clean the Air Purier to make sure
that the air inlet and ltered air outlet
are free from blockages.
• Check the condition of the lter and, if
dirty, replace with a new lter.
Noisy operation:
• Check the condition of the lter and if
dirty, replace with a new lter.
• Be sure that nothing is blocking the
air inlet and ltered air outlet.
EEC Statement:
• This machine was tested against the
89/336/EEC (European Economic
Community) for EMC (Electro
Magnetic Compatibility) and fullls
these requirements.
• This machine was tested against
the 73/23/EEC (European
Economic Community) for LVD (Low
Voltage Directive) and fullls these
tr o u b l e s h o o t i n g
requirements.
• This product is compliant
with EU Directive
2002/95/EC (Restriction
of Hazardous Substances
in Electrical and Electronic
Equipment), as amended
by Commission Decision
2005/618/EC on maximum
concentration values.
• This product is compliant
with EU Directive 2002/96/
EC on Waste Electrical
and Electronic Equipment
(WEEE).
IMPORTANT
INFORMATION
FOR CORRECT
DISPOSAL OF
THE PRODUCT IN
ACCORDANCE WITH EC
DIRECTIVE 2002/96/EC.
At the end of its working
life, the product must not be
disposed of as urban waste.
It must be taken to a special
local authority differentiated
waste collection centre
or to a dealer providing
this service. Disposing of
a household appliance
separately avoids possible
negative consequences for
the environment and health
deriving from inappropriate
disposal and enables the
constituent materials to
be recovered to obtain
signicant savings in energy
and resources. As a reminder
of the need to dispose
of household appliances
separately, the product is
marked with a crossed-out
wheeled dustbin.
t