5
GB
8.3 Industrial safety helmet attachment (table K)
These ear-muffs should be tted to, and used only with, the industrial safety helmets listed in the table.
8.4 Explanation of the industrial safety helmet attachment table
1. Helmet manufacturer
2. Helmet model
3. Helmet attachment (gure L)
4. Head sizes: S = Small, N = Medium, L = Large
8.5 Explanation of the testing and approval table (table M)
(M:1) This product is in conformity with the provisions set out in the following directives. Thereby it fulls the requirements
for CE marking.
(M:2) This product has been tested and approved in accordance with following standards.
(M:3) The product has been examined by.
9. SPARE PARTS/ACCESSORIES
3M™ Peltor™ HY79 Hygiene kit
Replaceable hygiene kit consisting of two attenuation cushions, two foam rings and two snap-in ear cushions. Replace at
least twice a year to ensure constant attenuation, hygiene and comfort.
3M™ Peltor™ HY100A Single-use protectors
A single-use protector that is easy to t to the ear cushions. Pack of 100 pairs.
3M™ Peltor™ HYM1000 Microphone protector
Moisture-resistant and wind-resistant hygienic tape that protects the speech microphone and extends its life at the same
time. Pack of 5 metres is sufcient for around 50 replacements.
3M™ Peltor™ M995 Wind shield for electret microphone
Effective protection from wind noise for electret microphone that also protects it and extends its life. One protector per pack.
3M™ Peltor™ACK053 Rechargeable battery
NiMH rechargeable battery that can replace two AA type 1.5 V standard batteries.
3M™ Peltor™ FR08 Power supply
Power supply for FR09/ACK053.
3M™ Peltor™ FR09 Battery charger
Charger for ACK053
3M™ Peltor™ 1180 SV Battery cover
3M™ Peltor™ MT53N-12 Electret microphone
Supplied as standard with product.
Important Notice
3M does not accept liability of any kind, be it direct or consequential (including, but not limited to, loss of prots, business
and/or goodwill) arising from reliance upon any information herein provided by 3M. The user is responsible for determining
the suitability of the products for their intended use. Nothing in this statement will be deemed to exclude or restrict 3M’s
liability for death or personal injury arising from its negligence.
Peltor™ is a brand owned by 3M, St. Paul, MN 55144-1000, USA.
To Next Page
Loading...
Need help?
General