3M Peltor WS5 - Page 9

5
&KDQJLQJVHWWLQJVLQWKH&RQ¾JXUHPHQX
7KHKHDGVHWKDVD&RQ¾JXUHPHQXZKHUH\RXFDQDGMXVWVHWWLQJV
To access the menu, press and hold the (–) and (+) buttons for 2 seconds (with
the headset switched on).
$FFHVVWRWKH&RQ¾JXUH PHQX LV FRQ¾UPHGE\DYRLFHVD\LQJ
“menu”.
To change the settings, use the (–) and (+) buttons. To move on through the
&RQ¾JXUHPHQXSUHVVEULH¿\RQWKH2Q2II0RGHEXWWRQ(A:13).
See quick guide for information on how the menu is set up and where the
functions are located.
Bass Boost
Bass Boost gives a fuller bass sound to streamed stereo music.
Music Limiter Mode
There are two settings for limiting the sound level when streaming music/audio
with Bluetooth
% ON
The limiter will reduce the volume level to 82 dB(A) Leq over 8 hours
% OFF limits the total sound exposure over 8 hours to 82 dB(A) Leq
If the volume is set above 82 dB (A) it will be reduced to a very low volume,
once the daily dose is reached.
 7KLVLVFRQ¾UPHGE\DYRLFHVD\LQJ “daily dose reached”.
The dosimeter will reset every 24 hours.
Warning: Daily dose coul be exceeded if batteries are removed and replaced,
or if factory default is activated.
Balance
Changes the left-right balance of the surround sound.
Equalizer
Changes the frequency character of the surround sound.
% Low
% Normal
% High
% Extra High
External Input (only applies to audio input J22 – A:12)
% OFF – use this mode when the J22 audio input is not in use
% ON – use this mode if a cord is plugged into the J22 audio input
% Microphone – use this mode if a boom microphone is plugged into the J22
audio input
Side tone volume (applies only to Hands Free Bluetooth sound)
% OFF
% LOW
% NORMAL
% HIGH
Side tone nuise reduction
21
2))
Reset to Factory Default
Resets all functions to the factory settings.
3:10 Connecting external equipment via a cord
External equipment can be connected via the J22 audio input (A:12) or
the 3.5 mm jack (A:11). For information on various cords, see Spare Parts/
Accessories (I).