3M™ Multimedia Projector X64 Product Safety Guide© 3M 2007 7
CAUTION
• To reduce the risk associated with environmental contamination:
-  Dispose of exhausted batteries in accordance with applicable federal, state, and 
local regulations.
•  To reduce the risk associated with explosion, and/or chemicals from a leaking 
batteries:
- Use only with battery type AA.
-  Orient the battery's plus (+) and minus (-) terminals of the batteries according to 
the markings found on the remote control.
- Do not leave the battery in the remote for an extended period of time.
  'RQRWKHDWGLVDVVHPEOHVKRUWUHFKDUJHRUH[SRVHWR¿UHRUKLJKWHPSHUDWXUH
- Do not carry batteries loose in your pocket or purse.
- Avoid eye and skin contact in the event that battery would leak.
- Do not mix used and new batteries.
-
Obey the local laws on disposing the battery.
• To reduce the risk associated with the impact of a falling projector:
-  Use only the 3M™ brand wall/ceiling mounting hardware kit if wall or ceiling 
mounting is desired.
,QVWDOODWLRQRIWKH0ZDOOFHLOLQJNLWPXVWRQO\EHSHUIRUPHGE\TXDOL¿HGSHUVRQQHO
-  Adhere strictly to the proper installation procedure as outlined in the installation 
instructions when installing the 3M™ wall/ceiling kit.
  $OZD\VRSHUDWHWKHXQLWRQDÀDWVWXUG\DQGKRUL]RQWDOVXUIDFH
• To reduce the risk associated with intense visible light:
- Avoid looking directly into the projector lens while the lamp is on.
• To reduce the risk associated with tripping and/or impact:
- Position the power cord and data cable so that they cannot be tripped over.