22
WATERPROOF HOUSING
The camera is submersible
up to 30m if the camera
is correctly sealed in the
Waterproof Housing.
To fit and test Waterproof Housing:
1. Release the secure clasp of the
Waterproof Housing.
2. Inspect the water sealing gasket (the
rubberised material) to be sure it’s in
good condition.
3. Test the integrity of the seal by closing
the Waterproof Housing without
inserting the camera. Submerse the
Waterproof Housing completely in a
bowl of water for about a minute.
4. Remove the Waterproof Housing from
the water, dry o and then open.
5. If the entire interior is dry, the
Waterproof Housing is safe for
under water use.
6. Make sure to put the camera in
the desired recording position
before inserting the camera in the
Waterproof Housing.
To Next Page
Loading...
