5th Wheel M2 - Page 2

EN-Assembly Instructions for 5th Wheel Scooter M2 EN-Assembly Instructions for 5th Wheel Scooter M2
01 02
This QR code is a video tutorial for product use. It is recommended to scan
this QR code to learn more about how to use the product.
1. The start button needs to be pressed for 2-3 seconds.
2. For safety, the factory setting of scooter M2 is non-zero start, you need to slide the
scooter to 3KM/H, and the switch can be used normally.
3. The scooter can be turned on normally and cannot ride in walking mode, but can only
be pushed.
4. Can't start when charging.
5. Do not throw away the manual, please refer to the manual for specific operations.
Pay attention
before riding！
3. Connect the main wire. 4. Tighten the screws.
1. Unlock and fix the switch. 2. Pull spring and bring out the main wire.