retrieve a lost connection or connect to a new receiver
1.
put the connection switch to 2.4G
2.
turn the mode switch to S or X mode, LEDs start to blink
3.
plug the receiver into your Switch or Windows device
4.
press and hold pair button for 3 seconds to enter its pairing mode, LEDs start to
rotate clockwise
5.
LED becomes solid when connection is successful
* 2.4g receiver can only connect to one arcade stick at a time
support
please visit support.8bitdo.com for further information and additional support
FCC regulatory conformance
：
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
To Next Page
Loading...
Need help?
General