8BitDo Arcade Stick
Instruction Manual
* power off: t
urn the mode switch to OFF
*
connection priority: wired connection > 2.4g wireless / Bluetooth connection
Switch
* motion controls, NFC scanning, IR camera, HD rumble, notification LED are not
supported, nor can the system be waken up wirelessly
2.4g connection
1.
put the connection switch to 2.4G
2.
turn the mode switch to S mode, LEDs start to blink
3.
plug the receiver into the USB port on Switch. Arcade stick will auto connect to
the receiver
4.
LEDs on both the arcade stick and receiver will become solid when connection is
successful
* press home button to continue to use the arcade stick when it is already on S
mode
* Switch system needs to be 3.0.0 or above for 2.4g connection. Go to System
Setting > Controller and Sensors > turn on Pro Controller Wired Communication
Bluetooth connection
1.
put the connection switch to BT
To Next Page
Need help?
General