Need help?Do you have a question about the 8STREME BLAZE and is the answer not in the manual?
General| Brand | 8STREME |
|---|---|
| Model | BLAZE |
| Category | Swimming Pool Cleaners |
| Language | English |
Replace damaged cables only via manufacturer or qualified personnel.
Ensure electrical system is protected by a 30mA Ground Fault Circuit Interrupter.
Children must not play with the appliance.
Never operate the robot outside of the water.
Always disconnect the transformer before performing maintenance.
Do not use any power cable or cord that is damaged.
Never operate the robot when people are present in the pool.
Do not use the swimming pool while the cleaner is operating inside it.
Press the switch on the power box to the ON position to activate the robot.
Check for trapped air; sink robot, turn upside down, and shake to release.
Check connections, clean basket/filter, ensure no objects block impeller/grills.
Verify power outlet, transformer connection, or if transformer is defective.
Check transformer-to-float connection or float swivel for issues.
Check float connection; if blue light is on but red isn't, float swivel may be defective.
Verify float connection and power; contact support if issues persist.
Check power source, ensure power is on, verify connections, and impeller for obstructions.
Check power transmission, rollers, impeller, and contact service if motor issue suspected.
Check floating cable connections, integrity, and connectors for damage or rust.
To Next Page
