7. Failure analysis chart (wireless) (Use this when modem is in factory defaults)
? Is the WL/ACT led ON
/ \
| Yes Is your computer connected to wireless network called “default”?
| / \
| | Yes Can you open Internet pages normally?
| | / \
| | | Yes Your wireless connection is OK *.
| | |
.2 | | No Can you open modem web management (http://10.0.0
)? (Password = password )
connection with correct VPI/VCI values has IP address *.
s Renew IP address with Release/Renew buttons. Start this chart over *.
her VPI/VCI values than modem has already configured,
step 3 are advised.
s as in step 5 is advised *.
pe ping 10.0.0.2 and press Enter)
eb management (http://10.0.0.2
| | / \
Yes Check from STATUS menu, that | | |
| | | / \
| | | | Ye
| | | |
| No If your connection needs ot | |
| | | make settings with your ISP VPI/VCI values as in
| | | If you have PPP connection, make setting
| | |
pen command prompt, ty | | No Does ping command replies? (O
| / \ |
| | | Yes Check that your browser have no proxy settings configured.
| | | / \ Can you now access to modem w
)?
| | | | Yes Check your ADSL line settings from your ISP. Start this chart over *.
duct
| | for example with needle when power is on. If reset does not help, send it to A-Link warranty **.
Check your computer network settings as in step 1 have been told. Does ping reply?
t this chart over.
You can try to reset the modem to factory defaults by pressing reset on back of the product
. If reset does not help, send it to A-Link warranty **.
it is activated and ready.
2. S
. Start this chart over **.
our modem wireless network as in step 2 is advised.
€/min + local network fee) or by E-mail : techsupport@a-link.com
| | | | |
| | | |
| | | No You can try to reset the modem to factory defaults by pressing reset on back of the pro
|
| | |
| | No
| | / \
| | | Yes Star
| | |
| | No
| | for example with needle when power is on
| |
| No 1. Make sure that your computer have wireless network card and
|
| can all wireless networks in range and connect to wireless network named default.
| 3
|
No Activate y
/ \ Is the WL/ACT led ON?
| |
| Yes Start this chart over.
|
No Send modem to A-Link warranty **.
*/ Other support issues and questions you can contact A-Link technical support:
0600-41020 (2,67
**/ Warranty: A-Link warranty More information from http://www.a-link.com
P.O.BOX 3
FIN-02941 Espoo, Finland
11
To Next Page
Loading...