Need help?Do you have a question about the A-P-A Eco-Swing 90 and is the answer not in the manual?
General| Brand | A-P-A |
|---|---|
| Model | Eco-Swing 90 |
| Category | Gate Opener |
| Language | English |
Emphasizes qualified installation and adherence to EN 16005 regulations.
Discusses responsible disposal of electronic components and batteries.
Details the various options for mode selection like Rocker, Key Operated, and LCD switches.
Lists the essential tools required for installation.
Provides critical advice and considerations before starting the installation process.
Provides specific dimensions and guidance for installing the push type unit.
Provides specific dimensions and guidance for installing the pull type unit.
Details the process of fitting the backplate and the main module assembly.
Describes how to fit optional components like display boards and battery backup.
Explains the procedure for fitting the operator's plastic end plates.
Covers the fitting of the two spindle covers to the gearbox.
Guides through the attachment of the drive arm for push type installations.
Details how to position and secure the main cover for the push unit.
Guides through the attachment of the drive arm for pull type installations.
Details how to position and secure the main cover for the pull unit.
Instructions for setting up and calibrating the unit using the optional display board.
Details connecting to and using the Wi-Fi interface for setup and calibration.
Steps to locate and connect to the ES90's Wi-Fi hotspot.
Information on the default password and accessing the system.
Overview of the four main pages for system access and their functions.
Details on configuring door speeds, hold times, and other parameters.
Allows changing the unit ID and engineer PIN for identification and security.
Lists common error messages and their meanings for troubleshooting.
Provides a list of operational status messages and their explanations.
Identifies the main components and connection points on the control unit PCB.
Illustrates the wiring connections for Optex sensors.
Illustrates the wiring connections for Hotron sensors.
Illustrates the wiring connections for BEA sensors.
Shows wiring diagrams for auxiliary components like relays and switches.
Details the wiring required for master and slave unit configurations.
Explains manual adjustment of speeds, timers, and status/error codes.
Details fitting the bracket for display/battery and enabling battery monitoring.
Guides on fitting extension parts for height adjustment and necessary components.
To Next Page