A.R.I. S-050 User Manual

17
IOM S-050
5.3.5. Cleaning and inspecting the components
• Thoroughly but gently wash and clean all the components under clean running water. Pay attention to the sealing
area inside the Body.
• Visually check the condition of the Rolling Seal [1] & [2]. If any cracks or tears are found remove it from the Float
and replace it.
• If replacement is necessary, slide out and remove the Rolling Seal Assembly [3]
• Take a new Rolling Seal Assembly and dip the tail end into the liquid soap solution [4]
1
2
3
4

A.R.I. S-050 Specifications

General

Brand	A.R.I.
Model	S-050
Category	Control Unit
Language	English