EasyManua.ls Logo

a2b Galvani - 5.2 Charging the battery; 5.3 Battery charging

Default Icon
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19page
owner´s manual
5.2 Charging the battery
1. Make sure that the Battery is turned OFF.
2. Plug the charger into the wall outlet. The LED
will illuminate GREEN when the charger is con-
nected to a wall outlet
3. Pull the rubber cover out of the battery.
4. Carefully align the connector pin and connect
the charger to the battery by plugging the con-
nector into the charger socket.
5. The LED will illuminate RED as long as the bat-
tery is charged.
6. When charging is complete the Indicator LED
will illuminate GREEN.
7. Carefully unplug the charger from the battery
by pulling the connector out of the battery socket.
Then install the rubber cover and unplug the char-
ger from the wall outlet.
8. Your battery is now ready for use.
5.3 Battery charging
To maximise battery life, recharge as soon as
possible after every use.
Avoid leaving the battery charger plugged
into your battery for more than 12 hours at a time.
Once the battery is fully charged, unplug the
charger from the wall outlet then carefully unplug
the charger from the battery pack.
Avoid charging the battery at a temperature
lower than 0 °C or over 40 °C. If possible charge
the battery at room temperature.
You may recharge the battery at any time, re-
gardless of its state-of-charge. As your battery
ages, it will gradually lose capacity. With proper
care and maintenance, your battery will retain up
to 80% of its capacity over at least 500 dischar-
ge/recharge cycles. As capacity diminishes, you
will notice a gradual drop-off in maximum range
capability. When range falls to an unacceptable
level, contact your A2B dealer for a replacement
battery.
Charging times hours
Before using battery for rst time 12
Fully discharged 5 – 6
Battery charging

Related product manuals