a2b Kuo+ - Page 16

16
Owner`s manual
6.4..4 Changing Power modes:
The electrical system of the A2B Kuo+ is offering you six power
modes.
Mode 0 is the mode without power supply from the system
(rides without power assistance). Mode 1 to 5 gives you power
assistance with Mode 1 giving the lowest assistance, ranging up
to Mode 5 which maximum assistance, enabling you to reach a
maximum speed up to 30.2 km/h = 18,7 mph (Europe 25 Km/H
=15.5Mph) pending on various external factors as e.g. rider weight,
wind, terrain etc.
The default Mode is Mode1; each time you press the Mode
button increases the assistance by one level. Once you pass Mode
5 it returns back to Mode 0 without any assistance.
6.4.5. Riding speed indicator
Default speed unit is KM/H, by pressing the info button its
interchanges between km/h and mph.
6.4.6. Battery Management System (BMS)
BMS system will indicate battery state of charge in bars, the state
of charge in percent, the total battery discharge cycles (CYCLES),
the battery voltage (V) and the battery temperature (°C).
After switching on the system, push down and at same
time the screen will show the discharge cycles; push down
again then it will show the voltage of battery.
One more time press down the temperature of the battery will
be shown.
For returning back to the main interface press at the
same time and .
6.4.7. TRIP and ODO indicator
Default setting after switch on the display is TRIP. Pressing the
button alternates to ODO mode to show the total accumulated
mileage.
To interchange between these two just press button.
6.4.8. Backlight function
Switch on the display, hold the button for 3 seconds switching
on the backlight.
To switch off the backlight press the button again for in 3
seconds.
6.4.9. Standby mode
With the system switched on and without any power output for 10
minutes the system will automatically go into the Standby mode in
order to save energy.