Quick Start Guide
www.up-board.org /www.up-shop.org / www.up-community.org
A single board computer with 40-pin GP-bus
to go with wide-range expansion modules.
1x UP board
1x active heatsink (attached)
1x RTC battery (attached)
You will need the following, not included:
• 5V / 4A Power adapter and power cord
• USB drive for OS installation
• A monitor with HDMI
• USB keyboard and mouse
• Ethernet cable or WiFi (purchased separately)
UP board
What’s in your kit?
Local router/network*
*Ethernet or WiFi
Development workstation
Connect hardware
2
Prepare your bootable USB drive
1
a. Insert the USB drive before connecting the 5V / 4A DC adapter.
b. Please connect HDMI before powering on the device. Upon receiving power, the board will turn on automatically.
c. The board is set to automatically try to boot from the inserted USB drive.
d. You do not need to make changes to the BIOS settings to install the operating system.
For more info on the BIOS and how to change the BIOS password, see https://wiki.up-community.org
Please refer to https://wiki.up-community.org/Setup for instructions on how to prepare the bootable USB drive.
To Next Page
Need help?
General
