Need help?Do you have a question about the A&A Manufacturing QuikDekClor and is the answer not in the manual?
General| Brand | A&A Manufacturing |
|---|---|
| Model | QuikDekClor |
| Category | Lighting Equipment |
| Language | English |
The QuikDekClor must be installed by a licensed or certified plumber or a qualified pool professional.
Read manual completely before installation. Consult A&A Mfg for questions. Use ABS to PVC transitional glue for connections.
Designed for independent return line. Using outside intended purpose may void warranty.
Lists all parts included with the QuikDekClor feeder, such as screws, lid, deck ring, lock, seal, stand-pipe, canister, and diverter.
DO NOT install the QuikDekClor over steps or benches.
Position the QuikDekClor according to the provided diagram and dimensions.
Set canister 2" above bond beam, positioning balance line 15" below form top.
Set canister flush with bond beam, positioning balance line 17" below form top.
Adjust lid and deck-ring after desired height is set and connection is made.
Glue a 2-inch pipe into canister, dry-fit 90° elbow. Glue 18-inch pipe to elbow and cap.
Configure balance line to extend into pool at a 90° angle to the wall.
Plumb main-line from filter, use gate-valve below Tee to regulate flow.
Install 0.75" PVC feed line to canister socket, dry-fit 90° elbow, glue 18-inch pipe and cap.
Drill out the 0.75" inlet port membrane with a 3/8" drill bit for pressure testing.
Install male adaptor, cut stand-pipe to length, install diverter, and gravity test connections.
One-year warranty for defects. Excludes freezing, negligence, improper installation, or use.
Contact place of purchase. Proof of purchase or manufacturing date required.
Please retain for your records. Record Date of Installation.
Fill out card and mail within 30 days or register online at www.amfg.com.
Mail to ATTN: WARRANTY DEPT, A&A Manufacturing, Phoenix AZ. Provide owner and purchase details.
To Next Page