Need help?Do you have a question about the A&D HV-60KGL and is the answer not in the manual?
Information regarding the equipment's compliance with FCC regulations for radio frequency energy.
Details the accessories and optional items included with the scale, depending on the model.
Provides guidelines for selecting an appropriate installation location and environment for the scale.
Offers essential advice and best practices for the correct and safe operation of the scale.
Instructions on how to properly store the scale when not in use, including battery removal.
Details the procedure for setting up the scale, including unpacking and initial assembly.
Step-by-step guide for installing batteries into Type L scale models.
Instructions on how to safely remove the pole assembly from the scale.
Explains the grounding procedure to prevent static electricity issues.
Explains the meaning of various symbols and indicators displayed on the scale.
Details the functions of each key on the scale's control panel.
Covers the fundamental process of powering the scale on/off and performing basic weighing.
Explains how to use the tare function to exclude container weight and display net weight.
Details the available weighing ranges for the HV-G series scales and how to select them.
Describes how to use the MODE key to change units and select operational modes.
Guides on how to store the unit mass for accurate counting of articles.
Explains the procedure to count articles using the stored unit mass.
Details how to store the reference mass for percentage calculations.
Explains how to read the percentage value of an item relative to the stored 100% mass.
Guides on setting parameters for the accumulation function in the function table.
Provides examples of how to use the accumulation function and its performance.
Details setting the upper and lower limit values for the comparator function.
Illustrates examples of using the comparator function with specific limit values.
Guides on setting parameters for the full/dribble batch function for filling machines.
Details setting parameters for the simple batch function, including limits and zero band.
Provides examples of using the simple batch function and its comparison results.
A table listing gravity acceleration values for different geographical locations.
Outlines the comprehensive steps required to calibrate the scale for accurate measurements.
Describes the process for setting and storing parameters using the function table.
A comprehensive list of all available parameters and their descriptions.
Specifies the data formats used for communication via the RS-232C interface.
Details the stream mode for continuous data output and printing.
Explains the command mode for controlling the scale from a computer.
Information about the extension load cell cable for remote indicator placement.
Details the OP-03 option for RS-232C, relay output, and buzzer functionality.
Describes the OP-04 option for RS-422/RS-485 interface with relay output.
Information on the built-in printer option for Type V scales.
Troubleshooting guide for common issues before contacting service.
Guidance on scale repair and when to contact an authorized service engineer.
To Next Page
General
