AAON SB series - Carbon Monoxide and Rotating Component Hazards; Grounding, Unit Handling, and Water Safety

8
CARBON MONOXIDE POISONING
HAZARD
Failure to follow instructions could
result in severe personal injury or
death due to carbon-monoxide
poisoning, if combustion products
infiltrate into the building.
Check that all openings in the outside
wall around the vent (and air intake)
pipe(s) are sealed to prevent
infiltration of combustion products into
the building.
Check that furnance vent (and air
intake) terminal(s) are not obstructed
in any way during all seasons.
WARNING
During installation, testing, servicing
and troubleshooting of the equipment
it may be necessary to work with live
electrical components. Only a
qualified licensed electrician or
individual properly trained in handling
live electrical components shall
perform these tasks.
Standard NFPA-
70E, an OSHA
regulation requiring an Arc Flash
Boundary to be field established and
marked for identification of where
appropriate Personal Protective
Equipment (PPE) be worn, must be
followed.
WARNING
GROUNDING REQUIRED
All field installed wiring must be
completed by qualified personnel.
Field installed wiring must comply with
NEC/CEC, local and state electrical
code requirements. Failure to follow
code requirements could result in
serious injury or death. Provide proper
unit ground in accordance with these
code requirements.
WARNING
UNIT HANDLING
To prevent injury or death lifting
equipment capacity shall exceed unit
weight by an adequate safety factor.
Always test-lift unit not more than 24
inches high to verify proper center of
gravity lift point to avoid unit damage,
injury or death.
WARNING
ROTATING COMPONENTS
Unit contains fans with moving parts
that can cause serious injury. Do not
open door containing fans until the
power to the unit has been
disconnected and fan wheel has
stopped rotating.
WARNING