Congratulations on getting your new Aaronia SPECTRAN
®
V6 Realtime Spectrum Analyzer. This quick start guide will
provide you with some important initial instructions for connecting it to your PC and measurement equipment. It also
shows how to install and configure the RTSA-Suite PRO PC software for performing measurements.
Check package contents
Before your new SPECTRAN
®
V6 can be used please verify that all necessary components are available and all
requirements are met:
USB Stick with manual, application
soware and other information
Power supply box
The SPECTRAN® V6 device itself
Power Supply (USB-C jack)
Power socket adapters
Inside the power supply box:
Below the device:
Power cable
(red, USB-C connectors on both ends)
USB cable labeled „Data”
(black, USB-A to USB-C)
USB cable labeled „Boost”
(black, USB-A to USB-C, not with RSA 250X)
Cleaning brush
To Next Page
Need help?
General
