ABB ACS880 P944 Series - Page 46

7. Connect the phase conductors of the input cable to the L1, L2 and L3 terminals and the
phase conductors of the motor cable to the T1/U, T2/V and T3/W terminals. Connect
the brake resistor conductors (if present) to the R+ and R- terminals. Tighten the screws
to the torque given in the figure below.
7 7 7
5
5
5
6 6 6
GroundingL1, L2, L3, T1/U, T2/V, T3/W, R-, R+/UDC+, UDC
2.9 N·m3.3 N·mR4
2.9 N·m5.6 N·mR5
8. Reinstall the shroud on the power terminals.
8
9.
Go to section Connecting the control cables – ACS880-01 frames R4 and R5 (page 47).
46 Electrical installation