ABB ACS880 P944 Series - Page 49

4. Connect the phase conductors of the input cable to the L1, L2 and L3 terminals and the
phase conductors of the motor cable to the T1/U, T2/V and T3/W terminals. Connect
the brake resistor conductors (if present) to the R+ and R- terminals. Tighten the screws
to the torque given in the figure below.
4
3
3
3
GroundingR-, R+/UDC+, UDC-L1, L2, L3, T1/U, T2/V, T3/W
9.8 N·m20 N·m30 N·mR6
9.8 N·m30 N·m40 N·m (30 N·m*)R7
9.8 N·m40 N·m40 N·mR8
9.8 N·m70 N·m70 N·mR9
*525…690 V
Electrical installation 49
11