What causes fouling of the compressor in my ABB charger?
Fouling of the compressor in your ABB charger, due to the feeding in of ventilation gases, may result from: * Heavy fouling of the compressor components: Clean compressor. * Material of compressor wheel corroded: Check the fuel and its corrosive components, and change fuel if necessary.
What to do if lubricating oil pressure is too low in ABB Marine Equipment?
If the lubricating oil pressure is too low, it could be due to several reasons. The oil filter might be heavily contaminated (clean it), the oil pump in the lubricating system could be defective (check / replace it), the manometer display might be wrong (replace the manometer), or the rotor axial clearance might be too large (contact an ABB Turbocharging Service Station).
How to deal with rubbing of rotating parts in ABB HT564102?
If you notice rubbing of rotating parts in your ABB Industrial Equipment, contact an ABB Turbocharging Service Station if there is any doubt about the extent of the rubbing. Also, have a dimension check carried out by an ABB Turbocharging Service Station.
How to fix sluggish start-up of ABB HT564102 Industrial Equipment?
A sluggish start-up of your ABB Industrial Equipment can occur if the turbocharger is contaminated. In this case, clean the turbocharger. Another possible cause is a damaged bearing. If the bearing is damaged, contact an ABB Turbocharging Service Station.
What to do if ABB Industrial Equipment is vibrating?
If your ABB Industrial Equipment is vibrating, it may be due to rotor unbalance. In this situation, contact an ABB Turbocharging Service Station.
Why is charge air pressure too low in ABB Marine Equipment?
Low charge air pressure can be attributed to an air receiver leak (make repairs), a poorly adjusted injection system (correct it), a faulty manometer display (replace the manometer), a contaminated filter silencer causing excessive pressure loss (clean it), a damaged compressor/turbine (contact an ABB Turbocharging Service Station), or high exhaust counterpressure (clean or repair the boiler or exhaust silencer).
What to do if ABB Battery Charger has vibrations?
If your ABB Battery Charger is experiencing vibrations, it may be due to rotor unbalance. Contact an ABB Turbocharging Service Station for assistance.
What to do if my ABB Industrial Equipment is vibrating?
If your ABB Industrial Equipment is vibrating, it could be due to a rotor unbalance. In this case, you should contact an ABB Turbocharging Service Station. Another cause may be damaged turbine or compressor or damaged bearing.
What to do if ABB Industrial Equipment has vibration?
If your ABB Industrial Equipment is vibrating, it could be due to rotor unbalance, in which case you should contact an ABB Turbocharging Service Station. Other potential causes include a damaged turbine or compressor, or a damaged bearing.
Why is my ABB Industrial Equipment start-up sluggish?
A sluggish start-up of your ABB Industrial Equipment can be attributed to several factors. The turbocharger may be contaminated and needs cleaning. Alternatively, there could be a damaged bearing, in which case you should contact an ABB Turbocharging Service Station. Other possible causes include a rubbing rotor or a foreign object present in the turbocharger.
General| Type | HT564102 |
|---|---|
| Poles | 3 |
| Mounting | Panel |
| Standards | IEC 60947-1, IEC 60947-3 |
| Handle color | Black |
| Handle without grip | Yes |
| Positions | 3 |
| Maintained | Yes |
| Illuminated | No |
| Bezel color | Black |
| Bezel material | Plastic |
| Contact block position 1-2 | No |
| Contact block position 3-4 | No |
To Next Page
