Why is there an increase in speed in my ABB HT568725 Industrial Equipment?
An increase in speed in your ABB Industrial Equipment could be due to a heavily contaminated nozzle ring (with 4-stroke application). If this is the case, you should contact an ABB Turbocharging Service Station.
Why is my ABB HT568725 Industrial Equipment making noises during run-down?
If you are experiencing noises during run-down of your ABB Industrial Equipment, it could be due to a contaminated turbocharger, which requires cleaning. Alternatively, it could be caused by a damaged bearing, in which case you should contact an ABB Turbocharging Service Station.
Why is the run-down time too short for my ABB HT568725 Industrial Equipment?
If the run-down time is too short for your ABB Industrial Equipment, it could be because the turbocharger is contaminated, and cleaning it may solve the problem. Another possibility is a damaged bearing, in which case you should contact an ABB Turbocharging Service Station.
What causes reduced fatigue strength in ABB HT568725 Industrial Equipment compressor wheel?
If the material of compressor wheel is corroded, causing reduced fatigue strength of the compressor wheel and compressor blade failure in your ABB Industrial Equipment, check the fuel and its corrosive components, and change fuel if necessary.
What to do if there is no signal from speed sensor in ABB HT568725?
If you are not getting a signal or the amplitude is poor on your ABB Industrial Equipment, it may be due to a fitting error. The screw plug for the sensor might have been fitted with an additional gasket (copper ring). Remove this gasket when fitting the speed sensor to ensure the correct distance from the sensor tip to the signal-generating sealing disc.
General| Brand | ABB |
|---|---|
| Model | HT568725 |
| Category | Industrial Equipment |
| Language | English |
To Next Page
