What to do if measured speeds are too high on my ABB Industrial Equipment?
If the measured speeds are too high in your ABB Industrial Equipment, it may be due to: * A contaminated sensor tip; dismantle the sensor, clean its tip, and refit the sensor using the specified tightening torque.
What to do if ABB HT587908 has rubbing of rotating parts?
If you suspect rubbing of rotating parts in your ABB Industrial Equipment, and you're unsure about the extent of the rubbing, it's best to contact an ABB Turbocharging Service Station. They can perform a dimension check to assess the situation.
How to fix a sluggish start-up in ABB Industrial Equipment?
If your ABB Industrial Equipment has a sluggish start-up, it might be due to a contaminated turbocharger, in which case you should clean it. Alternatively, a damaged bearing could be the cause, requiring you to contact an ABB Turbocharging Service Station.
What to do if rotating parts are rubbing in ABB HT587908 Industrial Equipment?
If you suspect rubbing of rotating parts within your ABB Industrial Equipment, and there is any doubt about the extent of rubbing, then an ABB Turbocharging Service Station must be contacted.
What to do if there is no signal from the speed sensor in my ABB Industrial Equipment?
If there is no signal or the amplitude is poor in your ABB Industrial Equipment, it is due to a fitting error. The screw plug for the sensor is fitted with an additional gasket (copper ring). When fitting the speed sensor, this gasket must be removed to avoid signal issues.
How to fix rubbing rotating parts in ABB HT587908 Industrial Equipment?
If the rotating parts of your ABB Industrial Equipment are rubbing, have a dimension check carried out by an ABB Turbocharging Service Station.
Why is the charge air pressure too high in my ABB HT587908?
If the charge air pressure is too high in your ABB Industrial Equipment, it could be due to: * A malfunction in the injection system; repair it or contact the manufacturer. * The injection being misaligned; set it correctly.
Why is there a reduction in speed in my ABB Industrial Equipment?
If you notice a reduction in speed in your ABB Industrial Equipment, it could be caused by: * Heavy contamination of the turbine; clean it. * Damaged rotor components or bearing; contact an ABB Turbocharging Service Station.
How to deal with rubbing of rotating parts in ABB HT587908?
If you notice rubbing of rotating parts in your ABB Industrial Equipment, and you have any doubt about the extent of the rubbing, then an ABB Turbocharging Service Station must be contacted. Also, have a dimension check carried out by an ABB Turbocharging Service Station.
Why does my ABB HT587908 have vibrations?
Vibrations in your ABB Industrial Equipment may be due to rotor unbalance. In this case, you should contact an ABB Turbocharging Service Station.
General| Poles | 3 |
|---|---|
| Mounting | Fixed |
| Standards | IEC 60947-2 |
| Type | Circuit Breaker |
| Rated Voltage | 690 V AC |
To Next Page