How to fix sluggish start-up of ABB Industrial Equipment?
A sluggish start-up of your ABB Industrial Equipment can occur if the turbocharger is contaminated. In this case, clean the turbocharger. Another possible cause is a damaged bearing. If the bearing is damaged, contact an ABB Turbocharging Service Station.
What to do if ABB Industrial Equipment has vibrations?
If your ABB Industrial Equipment is experiencing vibrations, it could be due to a rotor unbalance. In this case, contact an ABB Turbocharging Service Station. Vibrations may also be caused by a damaged turbine or compressor, or a damaged bearing.
What to do if ABB HT609106 Industrial Equipment has rubbing of rotating parts?
If you suspect rubbing of rotating parts in your ABB Industrial Equipment, and you're unsure about the extent of the rubbing, it's best to contact an ABB Turbocharging Service Station. They can perform a dimension check to assess the situation.
What to do if rotating parts are rubbing in ABB HT609106?
If you suspect rubbing of rotating parts within your ABB Industrial Equipment, and there is any doubt about the extent of rubbing, then an ABB Turbocharging Service Station must be contacted.
Is rubbing of rotating parts in ABB Industrial Equipment a problem?
Rubbing of rotating parts in ABB Industrial Equipment can be normal behavior and not a malfunction. However, if there is any doubt about the extent of rubbing, then an ABB Turbocharging Service Station must be contacted.
General| Product ID | HT609106 |
|---|---|
| Poles | 3 |
| Mounting | DIN Rail |
| Type | Miniature Circuit Breaker |
| Mechanical Life | 20000 cycles |
| Electrical Life | 10000 cycles |
| Standards | IEC |
To Next Page