Operation Manual / TPS44-F.. - TPS61-F..
Safety 2
Lifting loads 2.10 Page 33
© Copyright 2016 ABB. All rights reserved.
August 2017HZTL2412_ENRevision F
Lifting loads
2.10
WARNING
Suspended loads
Loads not suspended in compliance with regulations may lead to per-
sonal injury or accidents with fatal consequences.
τ Loads must always be fastened to technically perfect lifting gear with
sufficient loading capacity.
τ Make sure the load is suspended properly on the crane hook.
τ Do not let anyone stand beneath a suspended load.
Wear safety gloves to protect against mechanical hazards.
Wear safety helmet.
In the case of two or more suspension points, the slinging angle must not
exceed 45°. This avoids excessive loading due to inclined tensile loading.
τ Fasten turbocharger assemblies / components as described in respec-
tive handling steps.
τ Before attaching slings, allow turbocharger components to cool down
(maximum 80°C).
τ Use suitable protection at sharp edges.
τ Completely screw in assembly / fitting devices without fail so that they
cannot work loose during use.
τ Use assembly / fitting devices only for applications described.
τ Make sure removed turbocharger components stand safely and se-
curely.
To Next Page
Loading...
Need help?
General
