Finish Rake/Comb
Breaks up clumps of material and leaves a beautiful
signature finish. By adjusting the rear manual jack, the 1/2”
thick hardened-steel-rake, can pivot up to 90° into a variety
of finishing and grading positions. This adjustability enables
the rake to pulverize clods of material, level and finish no
matter the material consistency. Finish Rakes are made
up of smaller sections that can be individually ordered to
decrease cost when needing to replace a worn/damaged
tooth.
Visit: www.abisupport.com
16
Components
FINISH RAKE
Rascal Infield PRO and MVP
To Next Page
Loading...
