ABI Attachments RASCAL Series - Page 56

Visit: www.abisupport.com
56
ASSEMBLING 3PT HITCH TO EXISTING RASCAL FRAME
Existing Rascal Frame
Existing Rascal tube slides into
3PT Hitch brackets and small tube
slides into Rascal frame.
Bottom Plate mounts
under existing Rascal
Frame.
Existing holes in 3PT
Hitch for optional Electric
Actuator Control Box
(both sides).
(4) 1/2" Washers and Nuts
1/2" Washers and Nuts
1/2-13 x 4" Bolts thru 3PT Hitch brackets,
existing Rascal tube and short tube.
(4) 1/2-13 x 4" Bolts
thru both 3PT Hitch
Plates.
Short tube goes inside
existing Rascal tube.
Options (cont'd)